User Manual

MESH AND BRIDGE NODES
www.sensicast.com
2
22
2-
--
-12
1212
12
Serial Connection
To use a serial connection with the Mesh/Bridge node, insert the stereo plug end of the
Sensicast serial cable into the connector on the front of the node marked “10101”. Connect
the DB9 connector to your DTE serial device (e.g., a personal computer). The signals are RS-
232 levels.
Note
The serial cable is an option on the Mesh node; it is standard on the Bridge
node.
Connecting to the Screw Terminals
The screw terminals can accept wires from 28AWG to 22AWG. (Solid wire or stranded wire
that has been tinned works best.) Strip approximately 0.125” inches of insulation from the wire
before inserting them and tightening the screw.