User Manual

MESH AND BRIDGE NODES
www.sensicast.com
2
22
2-
--
-11
1111
11
Resetting the Mesh/Bridge Node
To reset the circuitry, turn the node off, wait for 3 seconds, and turn the node on again.
Mounting the Mesh/Bridge Node
Use the enclosed #4 wood screws to mount the node using one or both of the mounting holes.
The unit may also be attached using adhesives or double sided tape, allowing for the fact that
the device weighs 4.5 ounces.
For the best radio antenna performance, mount the unit on a vertical surface, oriented so the
label on the front of the node is readable.
Note
Avoid mounting the node near large pieces of metal.
Powering the Mesh/Bridge Node from the Barrel Connector
To power the node from the barrel connector, first turn off the node. Insert the Sensicast 6V
wall adapter into a 120VAC/60Hz outlet. Take the barrel connector that is attached to the wall
adapter and insert it into the “DC IN” connector on the node. Finally, turn the node on again.
Note
 Be careful not to insert the power connector into the serial jack.