Owners manual

15
preliminary test section). The energy level
lights will light up green on the level scale
according to the selected energy level.
4. Place the sensiLight™ Mini treatment
window on the desired treatment area
with full contact to the skin. If sensiLight™
Mini is not properly applied, the indicator
will be “momentary” orange. If your skin
tone is too dark/tanned, the indicator will
be “momentary” red. In these cases, the
sensiLight™ Mini will not trigger a pulse in
that area of skin.
5. Press the trigger button and hold it
pressed for continuous pulsing.
6. Press the trigger button once for single
pulse.
7. While pressing the trigger button, you
will see a bright flash, you will hear a
popping noise, and you may feel a mild
stinging and/or heat sensation.
8. Keep the trigger button pressed
and start moving the device with
each pulse to the next spot without
detaching it from the skin. The device
will immediately recharge and will be
ready for the next pulse. Repeat process
until the entire treatment are has been
covered and while constantly pressing
the trigger button by “gliding” it to the
next spot to be treated.
9. After the treatment, turn off the device
by pressing the “ON/OFF” button; an
orange indicator will light up while the
device is in the shutdown mode. Unplug
the unit after each treatment session.
Important notes:
• Try not to overlap pulses on the same
spot. Repeated pulses on the same spot
may cause burns.
• Do not treat the same area of skin more
than once per treatment as it may cause
skin irritation.
• sensiLight™ Mini will not trigger a pulse if:
• There is no full contact of the
treatment window with your skin
• Your skin tone is too dark or tanned