User Manual

4
Instructions
Mounting the Filter Holder
1. Align the adapter ring (not included) with the lens, making
sure that the branding on the adapter ring faces inward
toward the camera.
2. Screw the adapter ring onto the lens until tight.
3. Align the filter holder with the adapter ring so that the
locking pin is on top, and the film clips face away from the
camera.
4. Angle the top of the filter holder away from the camera and
fit the alignment teeth on the bottom of the filter holder into
the groove of the adapter ring.
5. Pull up on the locking pin and move the top of the filter
holder over the adapter ring and release the locking pin.
6. Make sure the edge of the filter holder is flush with the edge
of the adapter ring, and that the filter holder is securely in
place before proceeding.