FH-100-U AIRCRAFT ALUMINUM UNIVERSAL FILTER HOLDER for 100mm Filters – with Extra Security Lock User Manual
Thank you for choosing Sensei Pro The FH-100-U is a universal filter holder that allows the use of standard 4 x 4 (100mm) and 4 x 6 (100 x 150mm), 2mm thick filters with virtually any lens when using the appropriate adapter ring. It quickly and easily mounts onto the lens and is capable of holding two filters simultaneously. It can be adapted to include an additional slot for a third filter with the included film clips.
Overview Locking Pin Security Locking Screw Additional Film Clips and Screws 360° Rotating Filter Holder Film Clips Alignment Teeth 3
Instructions Mounting the Filter Holder 1. Align the adapter ring (not included) with the lens, making sure that the branding on the adapter ring faces inward toward the camera. 2. Screw the adapter ring onto the lens until tight. 3. Align the filter holder with the adapter ring so that the locking pin is on top, and the film clips face away from the camera. 4.
7. For additional security, tighten the locking screw by turning it clockwise. 8. Install a filter into the holder by sliding it into position between the film clips. Due to the snug fit, the filter may have to be slightly jiggled to glide into the clips. Note: Do not use excessive force that can damage the filter or the holder. Note: When rotating the filter holder, friction from the locking pin may cause some noise. This is normal and will not affect the performance of the FH-100-U.
Adding a Third Filter 1. Using a 5/64 flathead screwdriver, carefully remove the screws from the film clips. 2. Remove the top clips and insert the extra film clips by placing them under the top clips. 3. Make sure the new clips are oriented similarly to the other clips so that the curve of the clips is bending away from the base.
4. Replace the top clips by placing them on top of the newly added clips. As in the previous step, make sure the curve is oriented similarly with the other clips. 5. Replace and securely screw in the clip screws. If it is taking too much effort to insert a filter, check the orientation of the clips to make sure they are all curving in the same direction. Note: At the 45° rotation, vignetting will occur when using three filters.
One-Year Limited Warranty This SENSEI product is warranted to the original purchaser to be free from defects in materials and workmanship under normal consumer use for a period of one (1) year from the original purchase date or thirty (30) days after replacement, whichever occurs later.
