User's Manual

6. THE PRODUCT USES VERY STRONG NEODYMIUM MAGNETS WHICH CAN BE
HAZARDOUS IF SWALLOWED. KEEP THIS PRODUCT AWAY FROM CHILDREN AT
ALL TIMES
7. MAGNETS FOUND WITHIN THE PRODUCT CAN INTERFERE OR DAMAGE
CERTAIN MAGNETIC MEDIA, INCLUDING BUT NOT LIMITED TO OPTICAL HARD
DRIVES, TELEVISIONS, MAGNETIC STORAGE MEDIA, PACE-MAKERS AND OTHER
SENSITIVE ELECTRONICS
8. DO NOT DISPOSE OF ELECTRICAL APPLIANCE AS UNSORTED MUNICIPAL WASTE
USE SEPARATED COLLECTION FACILITIES
INDUSTRY CANADA STATEMENTS:
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this device may not cause interference, and (2)
this device must accept any interference, including interference that may cause undesired
operation of the device.
This equipment complies with the safety requirements for RF exposure in accordance
with RSS-102 §2.5.2. This equipment must be installed and operated in accordance with
the provided instructions and a minimum 20 cm spacing must be provided between the
antenna and any person’s body during wireless modes of operation.
INDUSTRY CANADA NOTICE:
“This device complies with ISED’s licence-exempt RSSs. Operation is subject to the following
two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause
undesired operation of the device”
INDUSTRY CANADA STATEMENTS:
Cet appareil est conforme avec Industrie Canada exempt de licence Rss standard(s).
Son fonctionnement est soumis aux deux conditions suivantes : (1) cet appareil ne peut
causer d’interférences, et (2) cet appareil doit accepter toute interférence, y compris des
interférences qui peuvent provoquer un fonctionnement indésirable du périphérique.
Ce dispositife est conforme à la norme de sécurité en matière d’exposition RF conformé-
ment à la RSS-102 §2.5.2. Ce dispositif doit être installé et utilisé conformément aux
instructions fournies et à 20 cm espacement minimal doit être prévu entre l’antenne et le
corps de toute personne pendant les modes sans fil de fonctionnement.
FCC NOTICE (for USA):
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
Federal Communication Commission (FCC) Radiation Exposure Statement: This equipment
complies with FCC radiation exposure limits set forth for an uncontrolled environment. In
order to avoid the possibility of exceeding the FCC radio frequency exposure limits, human
proximity to the antenna shall not be less than 20cm (8 inches) during normal operation.
The antenna(s) used for this transmitter must not be co-located or operating in conjunction
with any other antenna or transmitter.
No changes shall be made to the equipment without the Company’s permission as this
may void the user’s authority to operate the equipment.
DISCLAIMER:
THE PRODUCT USES RADIO TO WIRELESSLY COMMUNICATE DATA BETWEEN ITSELF
AND OTHER DEVICES. RADIO COMMUNICATION IS INHERENTLY NOT ALWAYS 100%
RELIABLE, AND AS SUCH, THE PRODUCT SHOULD NOT BE USED IN SITUATIONS IN
WHICH LIFE AND/OR VALUABLES ARE SOLELY DEPENDENT ON ITS FUNCTION.
WARNINGS:
1. DO NOT EXPOSE THE PRODUCT TO EXTENSIVE TEMPERATURE, FIRE,
CHEMICALS, OR EXPLOSIVES
2. DO NOT BRING THE PRODUCT INTO CONTACT WITH FOOD OR FOODSTUFF
3. DO NOT DISASSEMBLE THE PRODUCT; RECHARGE THE BATTERY, DISCHARGE,
SHORT-CIRCUIT OR INCINERATE
4. DO NOT KEEP THE PRODUCT IN CONTACT WITH EXPLOSIVE GASES
5. DO NOT PLACE THE PRODUCT IN A MICRO WAVE, OVEN, WASHING MACHINE,
LAUNDRY DRYER, OR ANY OTHER HEAT PRODUCING APPLIANCE
Note: This equipment has been tested and found to comply with the limit for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equip-
ment generates, uses and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to radio communica-
tions. However, there is no guarantee that interference will not occur in a particular installa-
tion. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.