User Guide

Complete Your Configuration
Page 49 of 49
5 Finishing Up/Support
Goal: Completing your Configuration
1. Click Save to set your finalized settings configuration.
2. Select FHDRM SD drive when prompted. Your configuration saves to your card.
3. Wait for confirmation that the software applied your settings configuration.
4. Click Eject SD Card, insert it into KP2, and power on your device.
5. You have completed your configuration.
Note: Apply device configurations over the air from the SmartAPI Workstation. See
the instructions
here. While KP2 is not mentioned, the same process applies.
5.1 Support Information
If you need additional support or an expert to walk you through this process, please
register and submit a ticket, or email us at [e-mail]. If you are
enrolled in SWAT, reach out to the integration team via Teams with any device
configuration questions.
Feel free to call our support team:
• North America, South America, APAC
[phone]
• EMEA
[phone]