User Guide

Event > ADAS
Page 26 of 49
1. Turn on ADAS feature capabilities by
clicking Use. This gives you access to
enable ADAS events and change
individual settings independently.
2. To mark the Bonnet Position
(vehicle hood’s horizontal pixel line)
and Horizon line, click Set.
• Use the pop-out window to set
each line and click OK to save.
3. Mark the Camera Height on the
windshield. This measurement is from
the ground to the center of the
camera lens. Set your camera height
in 10cm increments.
• Example: if the height is 173cm,
set the Camera Height as 170cm.
• This setting is integral to proper
ADAS calibration, so ensure you
have inputted measurements
correctly.