User Guide

4
Sensata INSIGHTS
AP User Guide
Key functions
Automatic Booting
Once the AP1 has been wired to your OBDII port
or vehicle power source, the AP1 will boot up
automatically. It will take around 55 seconds
for the unit to be ready to operate.
1. Video recording
Continuous record
This is the default mode for recording. Your AP1 begins recording after booting up and continues to record the entire
time the device is on. In this mode, the microSD card storage may ll up quicker and overwrite your oldest recordings
when it’s full. The resolution and frame rates can be set as per your requirements.
Event record
The unit will record when triggered by impact, various congurable driving events (e.g., speeding or forward collision)
or events triggered by the “Panic” (Rec) button. You can set the record time during the calibration setting mode.
Dual record, continuous + event
Continuous record les will be stored in the “Normal” folder, and event record les will be stored in the “Event” folder
on the microSD card.
Drive data
DRV data (drive data) will record driving information regardless of events. DRV les consist of GPS, G-sensor, ADAS
and OBD data. DRV les overwrite your device’s oldest data. DRV les upload to the server every 10 minutes by
default but can increase to every minute.
Time and date
This information will be provided by GPS satellites automatically.
2. Wi-Fi
To connect to the device via Wi-Fi, please press the “multifunction” button and hold for 5 seconds (long press),
wait 3 seconds and then connect directly to the AP1 via Wi-Fi using your mobile device.
3. Volume control
Please press the volume button to control. The volume level is 1 to 5.