Product Manual

The following tools are required for inverter installation: Crimper, Cable Ties,

Cutter, Drill, #2 Phillips Screw Driver, Slotted Screw Driver, Tape Measure, Wire

Cutters, and Wire Strippers.

NOTE: The inverter mounting location should provide adequate ventilation and

clearance to maintain room temperature during operation. At least ½” of clearance

is required on all sides.

1. Locate a suitable, secure, horizontal mounting surface as close to the batteries

as possible without being in the same airtight compartment.

2. Mount the inverter using four, ¼-20 steel bolts, flat and lock washers, and

nuts. The length of the bolts should be equal to the mounting material

thickness plus ¾”.

Mounting for Models: 12NP10, 12NP12, 12NP15, 12NP18, 12NP20,

12NP24 (units are in inches)

MOUNTING THE INVERTER

Installation Tools

Inverter Mountin

Recommendations