Product Manual

The LED Display Panel can be wired to the vehicle ignition circuitry to control

operation of the inverter. When the ignition is turned on, the inverter has a built-

in delay which will turn it on after 10 seconds. In order for the inverter to work in

this way the LED Display Panel must be programmed for this type of operation.

This is done by having either AC or DC power applied to the inverter and then

following these instructions:

Ignition Programming:

1. Press and hold [MENU] &

[DISPLAY/SELECT] for 5 seconds. A

Green “FAULT” LED comes on.

2. Press [MENU] once. Display scrolls:

CtL tab Off

3. Press [DISPLAY/SELECT]. Display stops

at:

OFF

4. Press [DISPLAY/SELECT] and the display changes to:

Ign

The “ON/STBY” LED will also blink Amber (if unit is connected to AC

power).

5. Press the [BATT TEST] key. Disconnect power to the system and complete

wiring as stated below.

The next step is to use an insulated female faston and using 18awg wire, connect to

the faston tab on the backside of the LED Display Panel. Wire the other end

through a 5 amp inline fuse to the ignition circuitry of the vehicle.

NOTE: It is advisable when using this feature to also take advantage of the Auto

Sleep option of the inverter. See page 13, item 5. If this option is used and the

inverter has gone to sleep, press [ON/OFF] to turn the inverter back on.

NOTE: Repeat steps 1-5 to turn this feature off again.

APPENDIX

nition Switch Control with the LED Dis

Panel