Product Manual

press the [DISPLAY/SELECT] key. The display will show “LO BATT”

followed by the recorded minimum low input condition (trough) voltage. The

mode will stay active for 1 minute or until the [BATT TEST] or [MENU] key

is pressed. The following message shows the low point at 10.1 volts.

Lo batt 10.1v

If there is not a value stored, the message will just say “Lo batt ---” and not list

any voltage.

You can clear the stored value manually by pressing the [DISPLAY/SELECT]

key while the message is scrolling. You will then see the following flash twice:

cLr batt

A newly recorded value will also clear the old value and replace it with the new.

6) Auto Sleep Mode

This feature is used to turn the inverter off if there has been zero watts drawn

for the set amount of time. For example if the sleep mode is set to 30 minutes

and 30 minutes of time has elapsed with no power being drawn from the

inverter, the inverter will shut off. The inverter must then be manually turned

back on again when needed. You can adjust this setting by pressing the

[MENU] key twice. You will then see:

Avto SLEp OFF

To change the setting press [DISPLAY/SELECT] repeatedly until the desired

setting appears. The options are OFF, 30M, and 15M. The default setting is

Off.

1) Bypass Relay: The loads attached to the inverter output will operate directly

from the external AC power line independently of the inverter ON/OFF

status. If the inverter is left ON (standby mode), the built-in bypass relay will

automatically cycle back and forth between “Inverter Power” mode and

“External Power” mode depending on the availability of the external AC power

line.

BATTERY CHARGER

The battery charger will engage automatically and independently of the inverter

ON/OFF status. The 3-step charging process modes are; Bulk, Acceptance, and

Float.

External Power Mode (Usin

LED Dis

Panel)