Product Manual

The following tools may be required
for inverter installation: Crimper, Cable
Ties, Cutter, Drill, #2 Phillips Screw Driver (with a magnetic end), Slotted
Screw Driver,
Tape Measure, Wire Cutters, and Wire Strippers.
NOTE: The inverter mounting location should provide adequate ventilation and
clearance to maintain room temperature during operation. At least ½” of
clearance is required on all sides except the bottom.
1. Locate a suitable, secure mounting surface as close to the batteries as possible
without being in the same compartment.
2. Mount the inverter using four ¼-20 steel bolts, flat and lock washers, and nuts.
Mounting for all models (units are in inches)
MOUNTING THE INVERTER
Installation Tools
Ø 0.280”
2.05”
10.75”
15.25”
8.3”
9.0”
8
Inverter Mounting Recommendations