Product Manual

(1) GFCI: Provides 120VAC output. Only replace with an approved GFCI.
(2) Status LED: This LED will show inverter operation mode and
troubleshooting information. See the table in the troubleshooting section
at the rear of the manual for further operation mode descriptions.
(3) Inverter On/Off: This switch turns the inverter On and Off.
(4) Output Breaker: Protects the inverter.
(5) Bonding lug: Connects to the system ground.
(6) DC input connections: Connects to the battery bank.
(7) Remote Switch Wiring Tab: Terminal is used to wire a customer
supplied remote.
(8) Remote Switch Connector: Connect a Sensata-manufactured LED lighted
assembly must be ordered separately.
(9) Sleep Mode/Shutdown Timer/Low Battery Settings: Use these switches to
configure the inverter (see next page for details).
NOTE – GFCI LED will blink while inverter is in Sleep Mode. List of
approved GFCI’s can be found in the appendix.
PHYSICAL DESCRIPTION
9
5
6
7
8
4
3
2
1
6
remote switch to this connector for remote inverter control. The remote switch