Product Manual

WARNING: Do not connect another source of AC power directly to
the output of the inverter. This will result in damage not covered under
warranty.
The inverter’s 120 VAC output power is provided at the GFCI receptacle or
through the hardwire connections for the “H” option.
“H” Option – Hardwire Interface:
R
emove the cover for hardwire AC wiring. Insert AC wiring through the cable
clamp to protect the wires from the metal edge of the hole. Use the supplied wire
nuts and wire Black to Black, White to White, and Green to Green.
Remote Inverter ON/OFF Switch
An optional remote switch with an integral LED can be purchased and used to
control the inverter. Mount the remote switch in a convenient location. Route
the cable to the inverter and plug into the connector on the back. See mounting
hole size in the Appendix section. Also see Appendix for 20' cable part number.
Note: The local indicator light will be green when functioning correctly,
while the remote ON/Off switch will have a solid red light when functioning
correctly.
Remote Inverter ON/OFF Switch – Customer Supplied
An optional customer supplied remote switch can also be used to control the
inverter. Mount the remote switch in a convenient location. Using 18 gauge wire
and an insulated ¼” female faston, wire between the “Remote ON/OFF”
connection on the right side of the inverter and the remote switch. Wire from the
remaining connection on the remote switch to the battery positive (+) terminal. Be
sure to install a 5-amp in-line fuse in series within 10 inches from the positive (+)
terminal of the battery.
AC OUTPUT CONNECTIONS
REMOTE INVERTER ON/OFF SWITCH
Remove these screws for
hardwire interface
10