Datasheet
DataSheet
Panel Mount
MECHANICAL SPECIFICATIONS
(1)
GENERAL NOTES
(7)
Do not forget to visit us at: www.crydom.com
Copyright © 2014 Crydom Inc. Specifications subject to change without notice.
Tolerances: ±0.02 in / 0.5 mm
All dimensions are in: inches [millimeters]
Screw Termination
1
OUTPUT
2
S OLI D S TA T E R ELA Y
4
INPUT
3
1.1
[27.9]
0.49
[12.4]
Mounting
Hole/Slot
0.19 [4.9]
DIA.
0.89
[22.6]
1.88
[47.6]
1.7
[43.2]
2.25
[57.3]
1.0
[25.4]
1.75
[44.5]
1.0
[25.4]
1.75
[44.5]
Hex Standoff Termination (“K” Option)
1
OUTPUT
2
S OLI D S TA T E R ELA Y
4
INPUT
3
1.1
[27.9]
0.49
[12.4]
Mounting
Hole/Slot
0.19 [4.9]
DIA.
1.88
[47.6]
1.7
[43.2]
2.25
[57.3]
1.0
[25.4]
1.75
[44.5]
1.04
[26.4]
(4 places)
0.93
[23.6]
1.0
[25.4]
(2 places)
(2 places)
Mounting
Hole/Slot
0.19 [4.9]
DIA.
2.25
[57.3]
1.1
[27.9]
0.49
[12.4]
1.88
[47.6]
1.7
[43.2]
2.32
[58.8]
1.0
[25.4]
1.75
[44.5]
1.0
[25.4]
1.75
[44.5]
1.22
[30.9]
Screw Termination, IP20
(1) All parameters at 25°C unless otherwise specified.
(2) Output will self trigger between 450-600Vpk, not suituable for capacitive loads.
(3) Heat sinking required, see derating curves.
(4) Increase minimum voltage by 1V for operations from -20 to -40°C.
(5) Turn-on time for instantaneous turn-on versions is 0.1 msec.
(6) AC models operating range is -20 to 80 °C.
(7) Option "K" is intended only for use in attaching a printed circuit board to the SSR or mounting the SSR to a printed
circuit board (PCB thicknesses from 0.031 to 0.093 inches [0.79 to 2.36 mm]).
(8)
All parameters at 50% power rating and 100% duty cycle (contact Crydom tech support for detailed report).
(9) Load can be wired to either SSR output terminal 1 or 2.
(10)
For single surge pulse Tc=25°C; Tj=125°C. For AC Output SSRs, AC Rms value of surge current equals the peak value divided by
√
2 (1.414).
For additional information or specific questions, contact Crydom Technical Support.