Installation Guide

Network CoNfiguratioN: StatiC
The Web 600’s default configuration will configure a static IP address of 192.168.1.250 if a DHCP server is
not located on your network. If your network is configured for DHCP support, please see the reverse side.
To setup your Sensaphone Web 600 without DHCP, follow these simple steps:
1. Using a cross-over cable (not supplied), plug one end into the Ethernet port on your Web 600, and
the other end into your computer’s network card.
2. Power on the Web 600.
3. There may be a short delay (1-2 minutes) when starting up of your Web 600. When the lights on
the network port light up, the startup sequence has been completed.
4. Open the web browser on your desktop computer and navigate to http://192.168.1.250/. Your web
browser should now display the Web 600’s Homepage.
5. Your Web 600 is now ready for use. Please consult the User Manual for further configuration
options.
SENSAPHONE
®
REMOTE MONITORING SOLUTIONS
901 Tryens Road • Aston, PA 19014 • PH: 610-558-2700 • ww.sensaphone.com