SENSAPHONE® Firmware Revision History and Upgrade Instructions Equipment Firmware: WEB600 v1.46 WEB600 with Relay Output v1.59 Release Date: July 15, 2013 The upgrade package has no prerequisites and supersedes all other upgrade or software fix packages previously distributed. Unpredictable results may occur if you do not follow the upgrade procedure completely.
WEB600 Embedded Firmware Feature and Correction Summary -----------------------------------------------------------------------------------------------------------------------------------NOTE: This document covers both the original WEB600 and the new WEB600 with Relay Output. The firmware files ARE NOT compatible. Pay careful attention to select the proper file when performing a firmware update. Contact Sensaphone Technical Support if you have any questions: (877)373-2700 or support@sensaphone.com.
• Corrected an issue on the web page with the white min/max bars not displaying correctly on the bar gauge. • Corrected an issue on the webpage with the Schedule pop-up on the Profile screen. Version 1.52 (June 5, 2012) • Fixed a web page issue when disabling a zone which caused the zone programming link to disappear on the Zones page. Version 1.51 (April 27, 2012) • First release. Original WEB600 Version 1.
• Changed how network settings are stored so that future firmware updates will not erase the network settings, even if all other programming gets reset to defaults. • In MODBUS and SNMP, the range and status flags were stored in reverse. They now correctly match the specification. • WARNING: Installing this update will reset the unit to factory defaults if the current firmware version is v1.30 or less. Version 1.
• Event messages now explain to the user if an event applies to a deleted contact. • Fixed a problem when viewing the Datalog if a zone was configured as a 4-20mA type and custom units were configured. As a result, the timestamp would not display properly when viewing the datalog. • Fixed a problem where an SMS destination was deleted but events still existed. The event entry would display improperly. Version 1.22 (June 26, 2009) • Added browser support for international characters.
WEB600 Firmware Installation Instructions WARNING: The firmware files for the original WEB600 and the new WEB600 with Relay Output ARE NOT compatible. You can identify which model you have by (a) Looking at the device and checking to see if the screw terminals at the far left of the terminal block are labeled Relay Output, or (b) check the Webpage of your device and see if you have a menu option that says “Outputs”.
If you have further questions regarding the WEB600, please contact Sensaphone Technical Support at 610.558.2700 x260, or by email at support@sensaphone.
