User guide

70
Cell682 User’s Manual
appendIX b: TroubleshooTIng
I CAN’T COMMUNICATE WITH MY UNIT LOCALLY.
• Make sure you have entered the proper PIN.
• Make sure the cable is connected from your computer to the Cell682.
• Make sure you have the right Com port selected (typically 1 or 2).
• Make sure the unit is receiving power.
I CAN’T ACCESS MY UNIT ON THE WEB PAGE.
• Have you entered the proper PIN and Password? The default password is
“cell682”
WHY IS THE ‘IN RANGE’ LED OFF?
• If the unit is not within range of the wireless network the LED will not turn
on.
• It typically takes 1-2 minutes from power-up for the Cell682 to recognize the
wireless network and turn on the LED.
• Make sure the unit is receiving power.
WHY IS THE ‘REGISTERED’ LED OFF?
• If the IN RANGE LED is lit but the REGISTERED LED is not, then the unit
is not activated yet.
• Make sure the unit is receiving power.
WHY IS THE ‘BATTERY OK’ LED OFF?
• There is no battery connected.
• The battery voltage is low.
WHY IS THE ‘POWER OK’ LED OFF?
• The main power has failed and the unit is running batteries.
• The voltage at the Vin terminals is low.
WHY IS THE ‘ALARM’ LED BLINKING?
• There is an unacknowledged alarm.
WHY IS THE ‘ALARM’ LED ON?
• There is an alarm but it has been acknowledged.
WHY WON’T THE UNIT SEND ME ALARM MESSAGES?