Instructions / Assembly

82
SENSAPHONE 1800 User’s Manual
RECORD AND PLAY CUSTOM VOICE MESSAGES
The following commands will allow you to record and play back custom
voice messages for the ID message (0) and each zone (1–8).
Description Touch-Tone Command
Record a Message S(7) + M(6) + (entry 0–8)
Description Touch-Tone Command
Play a Message W(9) + M(6) + (entry 0–8)
CONTROL THE RELAY OUTPUT
The following commands will allow you to check the status of the relay
output and to toggle the Relay Output On and Off.
Description Touch-Tone Command
Reciting the Output Status W(9) + R(7) + O(6)
Description Touch-Tone Command
Switching the Output S(7) + R(7) + O(6)
ACTIVATE MICROPHONE LISTEN-IN
The following command will allow you to activate the microphone listen-
in for the programmed duration.
Description Touch-Tone Command
Activate Mic Listen-in M(6) + I(4) + C(2)
REQUEST STATUS REPORT
The following command will initiate a status report.
Description Touch-Tone Command
Recite status report W(9) + S(7) + R(7)
REQUEST ALARM HISTORY
The following command will recite the alarm history.
Description Touch-Tone Command
Recite alarm history H(4) + I(4) + S(7)
HANG-UP
The following command will make the 1800 hang up the telephone line.
Description Touch-Tone Command
Hang-up the phone line B(2) + Y(9) + E(3)
If a security code is enabled, the 1800 will prompt you with “Enter
security code.” Enter the four-digit keypad security code plus “#” to
enter touch-tone command mode. If entered correctly, the 1800 will
respond with “OK” and you can proceed to enter the commands. If
entered incorrectly, the unit will give you one more chance. If it is
incorrect a second time, the unit will say “Error, goodbye” and hang up.