Instructions / Assembly

80
SENSAPHONE 1800 User’s Manual
“Output is off.”
“Good-Bye”
REMOTE COMMANDS VIA TOUCH-TONE PHONE
You can issue a number of commands to the 1800 remotely using a Touch-
Tone telephone. This command mode can be entered at any time during the
status report. Simply press a Touch-Tone and the unit will halt the report
and respond with “OK.” You are now in Touch-Tone command mode.
Commands are available to perform the following functions:
• Enable and disable zones, power monitoring, and sound monitoring
• Recite/Set High and Low alarm limits
• Recite/Set telephone numbers
• Record/Play custom voice messages
• Recite/Set the relay output
• Activate the microphone for listen-in
• Recite status report
• Recite alarm history
The commands are put together based on the letters of a touch-tone tele-
phone. See typical telephone keypad layout below.
Figure 1: A telephone keypad
Many of the commands use three letters that represent an abbreviation of
the selected command. For example, to Set a High limit on Zone 1 you
would press S + H + 1 (or in numeric form 7 + 4 + 1)
The tables below list all of the touch-tone commands that are supported.
Commands are listed in both character and numeric formats. The # key is
used as an ENTER key. Use the * key to represent a negative sign or to rep-
resent the [CODE] key when programming telephone numbers.