Instructions / Assembly

40
SENSAPHONE 1800 User’s Manual
If the sensor is configured as not used, the unit will respond “Error the zone
is off”. Refer to section 5.13 to designate as used.
1. Press the SENSOR ON/OFF key.
SENSOR
ON/OFF
2. Press the SET key.
SET
The 1800 will say “Enter Zone Number.”
3. Press the corresponding number of the Zone you wish to mark as
unused.
1
CALL
DELAY
4
MAX
CALLS
7
RECOGNITION
TIME
8
RESET
TIME
5
ALARM
LIMITS
6
2
VOICE
REPS
3
INTERCALL
TIME
CALIBRATE
The 1800 will respond by saying Zone 1–8, Power, or Sound “Off/On.”
Repeat the key sequence to place the Zone back in use.
EXIT DELAY
The Exit Delay feature is useful when you are using your 1800 for security
monitoring. This feature allows you to exit a building without tripping a
security alarm. When tripping an alarm is unavoidable, yet a true alert con-
dition has not actually occurred, the alarm response—including dial-out—
can be temporarily suppressed.
The 1800 is able to suppress and then reset its dial-out function automati-
cally through use of the Status Report. This is especially convenient when
an alert condition is created upon exiting a monitored door, and there is no
way to cancel from the local keypad.
The Exit Delay feature applies only to Zones configured as NO/NC.
You are planning to exit through a monitored door. Prior to exiting, you
initiate a Status Report recitation at the 1800 keypad by pressing [WHAT
IS], followed by [STATUS], (key sequence shown below). This allows you
the duration of the status report to exit without activating the 1800’s pro-