Full Product Manual

Chapter 7: Operation
97
REMOTE COMMANDS VIA TOUCH-TONE PHONE
You can issue a number of commands to the 1400 remotely using a
Touch-Tone telephone. This command mode can be entered at any
time during the status report. Simply press a Touch-Tone and the
unit will halt the report and respond with “OK.” You are now in
Touch-Tone command mode. Commands are available to perform
the following functions:
•Enableanddisablezones,powermonitoring,andsound
monitoring
•Recite/SetHighandLowalarmlimits
•Recite/Settelephonenumbers
•Record/Playcustomvoicemessages
•Recite/Settherelayoutput
•Activatethemicrophoneforlisten-in
•Recitestatusreport
•Recitealarmhistory
The commands are put together based on the letters of a touch-tone
telephone. See typical telephone keypad layout below.
Figure 1: A telephone keypad
Many of the commands use three letters that represent an
abbreviationoftheselectedcommand.Forexample,toSetaHigh
limitonZone1youwouldpressS+H+1(orinnumericform7+
4+1)