Full Product Manual

Sensaphone 1400 Manual
96
CALL-IN STATUS
You can also call into the 1400 using a Touch-Tone telephone
to obtain a status report. After answering, the 1400 will recite a
status report. Immediately following the status report, the 1400
allows you to use Touch-Tone commands to enable/disable zones,
changelimits,controltheoutput,etc.Seethenextsection,Remote
Commands via Touch-Tone Phone.
Belowisanexampleofavoicestatusreport:
“Hello, this is 555-2278, ‘Acme Medical Laboratory’
“Zone one, ‘Temperature in refrigerator one,’ 38 degrees
Fahrenheit, OK
“Zone two, ‘Temperature in refrigerator two,’ 40 degrees
Fahrenheit, OK
“Zone three, ‘Water pressure monitor,’ OK
“Zone four, ‘Nitrogen gas tank level in percent,’ 15, too low,
acknowledgedalarmexists
“Sound is OK”
“Power is ON”
“BatteryisOK”
“Output is off.”
“Good-Bye”