Full Product Manual

Chapter 5: Communication Programming
87
CALLBACK ACKNOWLEDGMENT
This is an optional feature that can be enabled using the keypad
(default=disabled). It allows an alarm to be acknowledged simply
by calling the unit and letting the line ring 10 times. When this
featureisenableditwilltemporarilymaketheRingsUntilAnswer
setto10whenanunacknowledgedalarmexists.Ifyoureceivea
call via Voice or Pager and are unable to send touch-tones, you can
call the unit back, let the line ring 10 times, and the unit will answer
and say “...Alarm Acknowledged.”
NOTE: If TAD is also enabled, then you must call the 1400,
let it ring once, hang up, and then call the unit back within 30
seconds. The unit will answer on 1 ring and acknowledge the
alarm.
To Enable the Callback Acknowledgment Feature:
1. Press SENSOR ON/OFF.
SENSOR
ON/OFF
2. Press CODE.
CODE
The 1400 will say “Callback Acknowledgment Enabled/Disabled” to
indicate that Callback Acknowledgment is enabled. Repeat the key
sequence to disable.