Full Product Manual

Sensaphone 1400 Manual
60
2.PressthePHONENUMBERkey.The1400willsay“Enter
Number.”
PHONE
NUMBER
T/P
3.SelectanassignedPhoneNumber(keys1–8),andpress
ENTER.
4
MAX CALLS
1
CALL DELAY
2
VOICE REPS
3
INTERCALL
TIME
5
ALARM LIMITS
6
CALIBRATE
7
RECOGNITION
TIME
8
RESET
TIME
ENTER
LOCK
The1400willsay“Number(1–8)erased.”
Numeric Pager Dialout
When programming the 1400 to dial a Numeric pager there are two
methods that can be used:
Automatic mode and Manual mode.
The only difference is that in Automatic mode the 1400 will
automatically try to sense when the call has been answered and
then send the ID Number and zone numbers. In some instances,
the automatic answer detection and timing from the 1400 is
incompatible with the paging service, and the Manual mode must be
used.
NOTE: If your phone system requires you to dial a
‘9’ followed by a pause to get an outside line, you
must use Manual mode and insert pauses at the end
of the number.
When the 1400 calls your Numeric Pager it will leave the
programmed ID Number along with the Zone number that is in
alarm. If it’s reporting a Power alarm, it will send the ID Number
followed by the number “0”; if it’s reporting a Sound alarm, the
1400 will send the ID Number followed by the number “9”. To
acknowledge the alarm you will have to call the unit back and enter
an acknowledgement code, otherwise the unit will continue dialing
the remaining numbers.