Users Manual

Multi-room mode
47
▷ Wait until the status LED on both the receiver and the transmitter lights
up green.
▷ Adjust the transmission power of the receiver to the desired setting as
indicated in the receiver's operating menu (System Settings menu -> RF
Power)
▷ Switch the receiver off and on again to apply this setting.
▷ Perform a walk test to check the transmission power (see „Performing
a walk test (reception quality)“).
▷ If necessary, re-adjust the transmission power and then repeat the
walk test.
▷ The master receiver must remain switched on for the following steps.
▷ Switch on all other receivers. These receivers synchronize with the
master receiver.
▷ Adjust all the receivers to the same transmission power as the master
receiver.
▷ Switch all receivers off and on again. Make sure the master receiver re-
mains switched on.
▷ After this rack has been configured, the receivers must only be
switched on and off together – not individually. Switch the complete
rack on and off using the on/off switch of the multi-outlet power strip.
▷ Switch off the rack in this room and repeat the above steps for config-
uring the rack in the next room.