User Manual

SL Rack Receiver DW
70
Installing the receiver in a rack
To install the receiver in a rack:
▷ Use the two supplied recessed head screws to secure the blanking
plate from the GA 4 mounting kit to the mounting angle of the receiver
as shown.
Make sure to use the correct side (the one with the round holes) of the
blanking plate to secure it to the mounting angle.
►
▷ Only insert the two small covering caps into the antenna holes if you do
not wish to install the rod antennae at the front of the rack.
▷ Slide the receiver with the attached mounting accessories into a 19"
rack.
Mounting the rod antennae to the front of the rack
To mount the rod antennae to the front of the rack:
▷ Connect the included antenna cables to the antenna sockets at the rear
of the receiver.
▷ Pass the other ends of the antenna cables through the antenna holes in
the blanking plate and screw them to the rod antennae as shown.
►
Connecting the AWM 2 / AWM 4 remote antenna to the receiver
Instead of the supplied rod antennae, you can also connect a remote anten-
na to the receiver. For more information, see „The AWM 2 antenna wall
mount“ and „The AWM 4 antenna wall mount“.
▷ Pay attention to the notes about antenna installation under „Recom-
mendations on antenna mounting“.