Users Manual

Using the EM 6000
139
System -> Help menu item
In this menu item, you can find the link to the English version of this instruc-
tion manual.
System -> TX Update menu item
This menu item lets you perform a firmware update for the transmitters.
This update is recommended after you perform a firmware update for the
receiver (see „Updating the firmware of the receiver“).
To open the TX Update menu item:
▷ Turn the jog dial in the System menu item until the TX Update menu
item appears in the selection frame.
▷ Press the jog dial to open the menu.
The following view is shown on the display.
►
• New shows the version of the new firmware that is available after the
firmware update for the receiver.
• Ch1 shows the firmware that is currently installed on the transmitter for
the receiving channel CH 1.
• Ch2 shows the firmware that is currently installed on the transmitter for
the receiving channel CH 2.
To start the firmware update:
▷ Press the Sync button for the desired channel.
▷ Hold the transmitter and its infrared interface in front of the infrared in-
terface of the receiver. See „Synchronizing devices“.
▷ Be sure not to interrupt the process.
If the firmware update is interrupted, the following icon is shown on the
transmitter’s display.
►
▷ If this is the case, repeat the process.