Microphone Instruction Manual

Adjusting settings via the operating menu

The extended menu “Advanced Menu“

Setting the transmission frequencies and the frequency banks

“U1” to “U6” – “Tune”

Via the “Tune” menu item, you can:

1. set a transmission frequency to be stored in the current channel of the

frequency bank (“U1” to “U6”)

2. or select a frequency bank (“U1” to “U6”) and a channel and assign this

channel a transmission frequency.

Setting a transmission frequency for the current channel

 Set the desired frequency.

When you have selected one of the system banks and then select

the “Tune” menu, the radio microphone automatically switches to

channel 1 of the frequency bank “U1”. In this case, “U1.1” briefly

appears on the display panel.

Upon delivery, the channels of the frequency banks “U1” to “U6”

are not assigned a transmission frequency.

When you are in the “Tune” menu item, the RF signal is

deactivated.

It is vital to observe the notes on frequency selection on page 27.

 Move the multi-function switch until the “Tune” menu item

appears.

 Press the multi-function switch

The frequency selection appears.

 Press the multi-function switch.

Your settings are stored.

You are back to the operating menu.

Tune

B.Ch: U1. 1

Tune

Advanced

Tune

“Stored”

543.200 MHz

543.200 MHz 543.200 MHz

Select the frequency

bank and confirm

Select the channel;

store the setting

Call up “Tune”

(special function)