Set810.
Set810.
Set810.book Page 21 Thursday, February 22, 2001 11:14 AM The SET 810 is an assistive listening system for your radio, TV, hi-fi system or similar sound sources at the volume you choose. The system allows you to move around freely without the constrictions of cables within the room where the transmitter is placed. The system uses invisible infrared light for sound transmission.
Set810.
Set810.book Page 23 Thursday, February 22, 2001 11:14 AM Connecting the transmitter (charging unit) English The rear of the transmitter is fitted with two audio inputs: A socket (LINE) for connection to the audio output or the headphone socket on your TV, and a microphone socket (MIC). Plug in one end of the connecting cable to the audio output or the headphone socket on your TV, and the other end to the LINE socket on the transmitter.
Set810.book Page 24 Thursday, February 22, 2001 11:14 AM English Connect the power cable to the POWER socket on the transmitter. Plug the power supply into a household electrical outlet.
Set810.book Page 25 Thursday, February 22, 2001 11:14 AM Where to place the transmitter English Place the transmitter so that the infrared light beam is pointed directly at the receiver, i.e. there should be no obstacles in the light path between transmitter and receiver. Guide the cables backwards. Avoid exposure to direct sunlight. Direct sunlight may interfere with the reception and may damage the transmitter.
Set810.book Page 26 Thursday, February 22, 2001 11:14 AM Using the stethoset receiver English When putting the stethoset receiver on, make sure the operating control is pointing downwards and the letters are at the front. The stethoset receiver automatically turns on if you pull the earbows apart.
Set810.book Page 27 Thursday, February 22, 2001 11:14 AM Adjusting the volume English Adjust the receiver’s volume with the operating control. Make sure your hand doesn’t cover the operating control completely. This may prevent interference-free reception. If you are not using the stethoset receiver, store it on the transmitter so that the battery can be recharged.
Set810.book Page 28 Thursday, February 22, 2001 11:14 AM English Turning the automatic compression system on Use the COM switch (compression) at the rear of the transmitter to turn the automatic compression system on. This system reproduces soft passages louder and decreases loud sounds. Choose the setting that suits your listening preferences. Use the MO/ST switch to choose between mono and stereo transmission. For mono TVs and when using the MKE 800 TV microphone, the switch must be set to mono (MO).
Set810.book Page 29 Thursday, February 22, 2001 11:14 AM Charging the battery English Place the receiver into the transmitter’s charging compartment, with the operating control at the front. The left LED on the transmitter must light up. Charge the battery for 24 hours before you use it for the first time. The normal charging time is 4-5 hours. A fully charged battery has an operating time of approx. 4 hours. Always store the receiver on the transmitter to ensure that it is fully charged.
Set810.book Page 30 Thursday, February 22, 2001 11:14 AM English Additional information This system uses infrared light which is emitted by the transmitter and received by the stethoset receiver. Please note that infrared light emitted by other light sources may interfere with the useful signal of the SET 810. If the light path between transmitter and receiver is obstructed by clothing such as scarves etc., the reception may also be disturbed.
Set810.book Page 31 Thursday, February 22, 2001 11:14 AM WARNING: English Listening at high volumes will damage your hearing.
Set810.book Page 32 Thursday, February 22, 2001 11:14 AM Accessories English Only use original Sennheiser spare parts and accessories. ATTENTION: Components from other manufacturers (e.g. for power supply or battery) may cause damage to the unit and will invalidate the waranty.
BA 151 rechargeable battery By using a spare accupack, you can use the stethoset receiver for more than four hours of continuous operation. Always store the spare accupack in the small charging compartment at the right of the transmitter. The right LED on the transmitter lights up green to show charging is taking place. When charging an battery in the small charging compartment, the charging time is 10-12 hours.
Set810.book Page 34 Thursday, February 22, 2001 11:14 AM English RI 810 additional stethoset receiver One transmitter can transmit to several receivers. Additional RI 810 receivers are available from your authorized dealer. RI 810 S clip-on receiver Instead of earbows, this receiver features a socket for connecting a headphone or a connecting cable which allows its use with a hearing aid.
Set810.book Page 35 Thursday, February 22, 2001 11:14 AM If problems occur...
Set810.book Page 36 Thursday, February 22, 2001 11:14 AM English Additional information for hearing aid acousticians Adjusting the earbow pressure Loosen the screw at the rear of the stethoset receiver. Move the screw in the long hole to the desired position (continuously adjustable). 1 = Low earbow pressure 2 = High earbow pressure Tighten the screw. 1 2 Adjustments for hearing disabilities Turn the operating control fully counterclockwise (0).
Adjusting the max. volume: Potentiometer turned fully counterclockwise Potentiometer turned fully clockwise 0 dB 125 dB Adjusting the bass response: Potentiometer turned fully counterclockwise Potentiometer turned fully clockwise attenuation of -25 dB at 100 Hz attenuation 0 dB English Set810.book Page 37 Thursday, February 22, 2001 11:14 AM The adjustments can also be made when the receiver is being used.
Set810.book Page 38 Thursday, February 22, 2001 11:14 AM English Technical Data System Modulation Carrier frequencies AF frequency response S/N ratio FM, stereo 2.3 / 2.8 MHz 40 Hz ....... 15 kHz 60 dB A rms Transmitter AF input voltage Audio input Microphone socket Charging time for battery Charging time (spare battery) Power supply Weight Dimensions 50 mV ...... 5 V 3.5 mm jack, stereo/mono 2.5 mm jack, mono approx. 4 h approx. 10-12 h 24 V DC via NT 810 mains unit approx.
Set810.book Page 130 Thursday, February 22, 2001 11:14 AM Änderungen vorbehalten Subject to alterations Sous réserve de modification Con riserva die modifiche Reserva de modificaciones Wijzigingen voorbehouden Med förbehåll för ändringar Sennheiser electronic GmbH & Co. KG D-30900 Wedemark Printed in Germany Publ.08/00 Telefon +49 (0) 5130/600-0 Telefax +49 (0) 5130/600-300 www.sennheiser.
