User guide

15
Specifying frequencies for an “evolution wireless G2” series receiver
without a scan
Note:
When you allocate frequencies without a frequency preset scan,
interference with transmitters in the vicinity of the system may result.
To display the frequencies in the bank:
왘 Select the “Continue without scan” option and confirm with “Next >”.
The window to the left opens.
왘 Select a channel bank (e. g. “Bank 1”).
The listed item is highlighted in blue.
왘 Confirm with “Next >”.
The window to the left opens. The frequencies in the selected bank are
listed at the left. A list of receiver names appears at the right.
You can allocate the frequencies manually or automatically. Manual
allocation allows you to assign the same frequency to two receivers. This
may improve reliability.
To allocate frequencies manually:
왘 Click on the desired frequencies listed at the left.
왘 Hold down the mouse button and drag the selection to a receiver in the
list at the right to which you want to allocate this frequency.
The frequency appears after the name of the receiver.
왘 Repeat this procedure to allocate frequencies to other receivers.
왘 Confirm with “Finish”.
The “Frequency Management Wizard” window closes. The selected
frequencies are updated in the display field and transmitted to the
devices.
To allocate frequencies automatically instead:
왘 Click on the “Allocate automatically” button.
The frequencies are allocated to the receivers in succession
automatically.
왘 Confirm with “Finish”.
The “Frequency Management Wizard” window closes. The selected
frequencies are updated in the display field and transmitted to the
devices.