User guide

Show connected receivers

The “Easy Setup” window displays all receivers connected to the NET 1

with their frequency range and the ports on the NET 1 occupied by

receivers.

Note:

Use “< Back” to return to the previous window; use “Next >” to

proceed to the next window. Use “Cancel” to terminate “Easy Setup”.

In this window you can select a receiver with which a frequency preset scan

should be performed or whose frequency values should be transmitted to

all other receivers without a frequency preset scan (see next section).

To select a receiver:

왘 Click on the line in the list and confirm with “Next >”.

Allocating frequencies to receivers

You can allocate unused frequencies in various ways:

y After a frequency preset scan:

To find occupied as well as unused frequencies in the current vicinity of

the system, perform a frequency preset scan. Then allocate the unused

frequencies to the receivers (see next section).

y Without a frequency preset scan:

To allocate to receivers already known unused frequencies in the

vicinity of the system, specify these frequencies without a scan (see

“Specifying frequencies for an “evolution wireless G2” series receiver

without a scan” on page 15).

Performing a frequency preset scan for an “evolution wireless G2” series

receiver

To find occupied frequencies:

왘 Select the “Preset Scan” option and confirm with “Next >”.

The frequency preset scan starts and a progress bar appears.

Note:

y The frequency preset scan is always performed for all frequencies in

every channel bank.

y For receivers from the “evolution wireless G2” series, the

frequencies are organized in banks and stored in the receivers. For

EM 3532 dual receivers, the frequencies are selected from tables

that are supplied together with the “WSM” PC software. As for

“evolution wireless G2” series receivers, these tables are organized

in banks.