User guide

10
Transmitting the firmware to the receivers
To transmit the firmware to the receivers:
왘 Click on “OK”.
The firmware is transmitted to the receivers. On the NET 1, the yellow
LED “REMOTE” lights up.
The window to the left opens. The firmware is transmitted to the receivers.
After the firmware in the receivers has been updated successfully, the
window to the left appears
왘 Click on “OK”.
Note:
While the firmware is being transmitted to a receiver, the receiver's
display switches shut off.
Once the firmware has been transmitted successfully, the receiver's
display switches on again. The receiver appears as active in the system
window.
Transmitting the firmware to the transmitters
The window to the left opens. You can now update the firmware in the
transmitter. On the NET 1, the yellow LED “DATA LINK” flashes. LEDs 1 to
10 light up briefly in succession, indicating that the NET 1 is ready to
update the firmware in the transmitters.
왘 Hold the first transmitter in front of the infrared port (“DATA LINK”) on
the NET 1.
The firmware is transmitted. During this operation, LEDs 1 to 10 flash
simultaneously. Once the transmission has been completed, LEDs 1 to
10 light up briefly in succession. You can now place the transmitter to
the side.
왘 Hold all remaining transmitters in front of the infrared port on the
NET 1 in succession.
왘 Once you have updated all transmitters, click on “Close”.
The window closes.