Instruction manual
Table Of Contents
- EW500G3_US.pdf
- LeerSeiteGross.pdf
- EW500G3_529662_0109_US_INT.pdf
- Important safety instructions
- The ew 500 G3 evolution wireless series
- Product overview
- Putting the devices into operation
- Using the devices
- Overview of the operating menus
- Cleaning the devices
- If a problem occurs ...
- Specifications
- Manufacturer Declarations
- LeerSeiteGross.pdf
- EW500G3_Rueckseite.pdf
Using the devices
24
SKM 500
You can deactivate the RF signal on switch-on. For more information, refer to the chapter
“Switching the devices on/off” on page 20.
To deactivate the RF signal during operation:
Audio signal is muted
Transmitter’s display panel: “MUTE” is displayed
Receiver’s display panel: “TX Mute” is displayed*
* only when activated on the receiver (see above)
Audio signal is activated (muting is deactivated)
Transmitter’s display panel: “MUTE” is not displayed
Receiver’s display panel: “TX Mute” is not displayed
RF signal is deactivated
Transmitter’s display panel: Transmission icon is not displayed
Receiver’s display panel: “RF Mute” is displayed*
* only when activated on the receiver (see above)
RF signal is activated
Transmitter’s display panel: Transmission icon is displayed
Receiver’s display panel: “RF Mute” is not displayed
You can also deactivate the RF signal on switch-on. For more information, refer to
the chapter “Switching the devices on/off” on page 18.
Using the ON/OFF button, you can also activate/deactivate the RF signal during
operation. To do so, briefly press the ON/OFF button and proceed as described on
page 19.
When one of the standard displays is shown on the display panel, press the
ON/OFF button.
“RX Mute On?” appears on the display panel.
Proceed as described on page 20.
SET