Microphone Brochure

Using the receiver
20
To switch the receiver to standby mode:
To completely switch the receiver off:
왘 Disconnect the receiver from the mains by unplugging the mains unit
from the wall socket.
Synchronizing a transmitter with the receiver
You can synchronize a suitable transmitter of the ew 100 G3 series with
the receiver. During synchronization, the following parameters are trans-
ferred to the transmitter:
왘 Keep the STANDBY button  pressed until “OFF” appears on
the display panel.
The receiver switches to standby mode.
When in the operating menu, pressing the STANDBY button  will
cancel your entry (ESC function) and return you to the current stan-
dard display.
Setting Transferred parameters
“Frequency Preset” Currently set frequency
“Name” Freely selectable name currently set on the receiver
“Pilot Tone” Current pilot tone setting of the receiver
(“Inactive”/“Active”)
It is vital to observe the notes on frequency selection on page 42.