Microphone User Manual

65
Inserting and changing the battery
씰 Slide the cover of the battery compartment  in the direction of the
arrow until it clicks audibly and open the cover.
씰 Insert the 9 V PP3 battery (IEC 6 LR 61). Please observe correct polarity
when inserting the battery.
씰 Close the battery compartment.
Plugging the transmitter onto the microphone
씰 Plug the transmitter’s XLR-3 connector  onto the microphone’s
XLR-3 socket.
씰 Tighten the locking ring .
Note:
The transmitter uses the microphone body as an antenna – therefore
only microphones with a metal casing should be used for best signal
transmission.
Switching the transmitter on/off
씰 Press the ON/OFF button  to switch the transmitter on. The red
LED  lights up.
씰 For phantom powered condenser microphones: Via the menu, switch
on the phantom powering (P 48) ( “6 Operation”).
For dynamic microphones: Via the menu, switch off the phantom
powering (P 48) ( “6 Operation”). With the phantom powering
switched on, the operating time of the battery will be reduced to
approx. 5 hours.
씰 To switch the transmitter off, press the ON/OFF button until “OFF”
appears on the display. You can then release the button. The red LED
goes off.
Note:
Switch the plug-on transmitter off before changing the microphone.
Muting the transmitter
Use the MUTE switch  to noiselessly mute the transmitter’s audio signal
(this switch does not switch off the transmitter).