Instruction manual

Product overview

Command display (status display of the audio outputs AF and

Command)

The command display is only available with the EM 3732-II COM twin

receiver.

Besides the two audio outputs K and M the EM 3732-II COM twin receiver

also features the two command outputs J and L.

Via the “Command” menu, you can configure the receiver so that – with

the command button of the transmitter pressed – the audio signal is

available at only one of the outputs or at both (see “Configuring the audio

outputs of the EM 3732-II COM” on page 34).

The command display 쐎 shows the audio output at which the

transmitter’s audio signal is available.

When “AF” lights up brightly, the audio signal is available at the audio

output K and/or M.

When “AF” does not appear, the audio signal is not issued on the audio

output K and/or M.

When “COM” lights up brightly, the audio signal is available at the

command output J and/or L.

When “COM” does not appear, the audio signal is not issued on the

command output J and/or L.

LEDs for booster supply of antenna inputs

The LEDs for booster supply of antenna input A N and/or B S light up

when:

• the booster supply voltage is applied to the corresponding antenna

input A O and/or B R.

The LEDs for booster supply of antenna input A N and/or B S go off

when:

• the booster supply voltage for the corresponding antenna input A O

and/or B R is switched off or

• the booster supply voltage is short-circuited or overloaded.

COM