Specifications

18
Using the transmitter
Switching the transmitter on/off
왘 Press the POWER button  to switch the transmitter on or
off.
After switch-on, the LC display is backlit and the last
transmission frequency set is displayed.
Until the PLL has locked on the desired transmission frequency,
the transmitter is muted. “MUTE” appears on the display and
the LCD bargraph for RF output power (RF)
 indicates 0 %.
Note
The POWER button  works in the secondary circuit of the
integrated mains transformer, and thus only switches the
low voltage side. For larger installations with several
transmitters, a complete mains disconnection can best be
achieved by a central ON/OFF switch.
Connecting the headphones/monitoring the audio signal
Attention! High volume!
Even short exposure to high volume levels can damage your
hearing! Set the volume for the connected headphones to the
minimum before putting the headphones on. Do not listen at
higher volume levels than with loudspeakers.
왘 Connect headphones with a ¼“ (6.35 mm) stereo jack plug
to the headphone output
 to monitor the stereo audio
signal present at the audio inputs
 AF IN (L) and
 AF IN (R) + MONO.
Note
Even during mono operation, the left and right channel are
reproduced separately via the headphones.