Instruction manual
Table Of Contents
- Important safety instructions
- The EK 100 G3 diversity receiver
- Delivery includes
- Product overview
- Putting the diversity receiver into operation
- Using the diversity receiver
- Using the operating menu
- Adjusting settings via the operating menu
- Synchronizing a transmitter with the diversity receiver
- Cleaning the diversity receiver
- Recommendations and tips
- If a problem occurs ...
- Accessories
- Specifications
- Index
8
Putting the diversity receiver into operation
왘 Lift one side of the belt clip 씌 as shown.
왘 Press down the belt clip 씌 at one fixing point and pull it out of the
receiver housing.
왘 Repeat for the other side.
왘 Place the perforated plate 씉 onto the rear of the receiver.
왘 Reinsert the belt clip 씌.
왘 Use one of the supplied line cables to connect the line input of the
camera to the socket 쐃.
The ground connection of the line cable serves as the antenna for
the second diversity section. For details on the connector assign-
ment, refer to the diagram on page 24.
씌
쐃