Diversity Receiver Instruction Manual

7
Putting the diversity receiver into operation
Putting the diversity receiver into
operation
Inserting the batteries/accupack
For powering the diversity receiver, you can either use two 1.5 V AA size
batteries or the rechargeable Sennheiser BA 2015 accupack or the DC 2
power adapter (see “Accessories” on page 23).
왘 Open the battery compartment by pushing the two catches 쐅 in the
direction of the arrows and open the cover 쐎.
왘 Insert the two batteries or the accupack as shown above. Please
observe correct polarity when inserting the batteries/accupack.
왘 Close the battery compartment by pressing on the center of the
cover 쐎.
The battery compartment cover 쐎 locks into place with an audible
click.
Charging the accupack
To charge the BA 2015 accupack:
왘 Insert the diversity receiver into the L 2015 charger (see “Accessories”
on page 23).
Mounting the diversity receiver to a camera
Use the supplied CA 2 camera adapter to mount the receiver to a camera’s
flash mount.
왘 Determine where on the perforated plate 씉 the flash mount
adapter 씊 will need to be fastened so that the receiver can best be
attached to the camera.
왘 At this position, place a square nut 씋 under the perforated plate 씉.
왘 Fasten the flash mount adapter 씊 to the perforated plate 씉 using the
square nut 씋.
The L 2015 charger can only charge the combination BA 2015
accupack/diversity receiver. Standard batteries (primary cells) or
individual rechargeable battery cells cannot be charged.
쐎
쐎
쐄
쐅
씉
씊
씋