Instruction manual

7
If you use passive antennas only, the DC supply voltage
can be turned off. To do so, remove the two input modu-
les (see “Exchanging the input modules” on page 7) and
set the two switches DC-Feed ANT A and DC-Feed ANT B
쐈 to position “OFF”.
Connecting the receivers
Up to eight receivers, e.g. EM 3031, or eight twin receivers,
e.g. EM 3032 or EM 3532, can be connected.
왘 Use BNC cables to connect the receivers to the BNC
sockets 쐄 and 쐎 as follows:
First receiver:
Diversity section “A” to A1, diversity section “B” to B1.
Second receiver:
Diversity section “A” to A2, diversity section “B” to B2.
etc.
Connecting the mains cable
왘 Connect the mains cable to the IEC mains socket 쐅 and
to the mains.
The ASA 3000 has no power switch. The unit is ready for
operation as soon as it is connected to the mains.
Note:
The ASA 3000 can be connected to any mains power
supply with 100 V to 240 V AC (50 to 60 Hz).
Exchanging the input modules
The unit is fitted with two wideband input modules (470 to
870 MHz) which are suitable for most applications. Howe-
ver, to ensure optimum reception reliability, we recom-
mend using two selective input modules (60-MHz window)
(see “Accessories” on page 10).
쐈
쐄
쐎
쐅