ADN System Instruction Manual

ADN Digital Conference System | 157
Using the “Conference Manager” software
Activating/deactivating automatic loading of a configuration
To automatically load a saved configuration at startup of the conference system:
왘 In the menu bar, click “Global Menu” > “AutoLoad...”.
The “Autoload Properties” window appears.
왘 Establish a connection to the central unit (see page 154).
왘 Select the “Enable Autoload” option button.
왘 Select the desired configurati
o
n from the drop-down list.
왘 Click “OK”.
At the nex
t startup of the conference system, the selected configuration is
automatically loaded in “Live” operating mode.
To deactivate automatic loading of a configuration:
왘 Select the “Disable Autoload” option button.
왘 Click “OK”.
Eliminating connection problems when a configuration is autoloaded
If no connection to the central unit can be establis
hed or if the configuration cannot
be found, an error message appears.
왘 Check if the central unit is correctly connected
*
(see page 127) and switched on
(see page 77).
왘 Make sure that the network communication
between the software and the cen-
tral unit is not blocked by a proxy server and/or a firewall.
왘 If necessary, disconnect an ex
isting connecti
on to the central unit in order to
establish a new connection (see next section).
왘 Click “Retry”.
Saving a configuration
You can save any number of configurations on either the central unit or locally on
the conn
ected Windows PC.
To save a newly created configuration on the central unit:
왘 In the menu bar, click “Global Menu” > “Save”.
The “Save Conference” window appears.
왘 If necessary, establish a connection to the central unit (see page 154).
왘 Select the “Save Conference Document on CU ######” option button.
왘 Enter a file name into the drop-down list box.
*
only if you are using the Windows version of the software