ADN System Installer Instruction manual
Content Content Installation requirements .................................................................................................. 4 Selecting updates ................................................................................................................ 4 ADN System Update............................................................................................................ 5 Establishing the connection ...............................................................................
This instruction manual describes how to use the ADN System Installer. With this installer you may install and update the following ADN software components: For the central unit: • Main software • Main drivers • Language drivers for the operating menu • Main driver verification (verifies that the main drivers and the language driver components have been updated correctly).
License of agreement Read the terms of this license agreement and any provided supplemental license terms (collectively "Agreement") carefully. The software this license applies to is protected by copyright law and other international legislation, regulations and agreements about intellectual property. By installing, using or copying the software, you agree to be bound by the terms of this agreement.
Installation requirements Installation requirements Note: If the network has been already setup successfully, no further steps are needed (e.g. by configuring the previously installed Conference Manager application). This is also valid for the ADN system installer. A PC with Microsoft Windows 7 und 8, Windows Vista or Windows XP with Service Pack 2 or higher is required.
ADN System Update 왘 Select the required components you want to install: Update the software/firmware of the ADN hardware components (central unit, delegate and chairman units and antenna module units). For further information see also the following chapters of this instruction manual. Update the ADN Conference Manager on your local client PC. For further information see also the “ADN Instruction manual“, chapter “Installing the Conference Manager software“.
ADN System Update If you have a system release (< 1.2.1.0) installed, the following error message will appear: First please install the official release 1.2.5.0 from our website. If the central unit is connected sucessfully, button will change to [Disconnect from a Central Unit]. The IP address and the serial number of the connected central unit is displayed below . If the related connection to the central unit has been lost (e.g.
ADN System Update Overview of the update stage window Position Function/short description The ADN System Installer has several update stages. The current update stage is also shown continously in . However, depending on the system release currently installed on the central unit, the actual number of update stages may vary.
ADN System Update Updating the CU-System Runtime. 왘 Click on [Next >] to update these component: 왘 Confirm the following dialog with [Ok]. Before you start the update, observe the instructions of the next dialog box. If you click on [Cancel] you will return to the previous window above.
ADN System Update 왘 If this part of the update is finished, shows “UPDATE COMPLETE“. Click on [Next >] to proceed with the next update stage.
ADN System Update 왘 Confirm the following dialog with [Ok]. Before you start the update, observe the instructions of the next dialog box. Then click on [Done] to start the update of the three components. If you click on [Cancel] you will return to the previous window above.
ADN System Update 왘 If this part of the update is finished, shows “UPDATE COMPLETE“. Click on [Next >] to proceed with the next update stage. If you want to include additional wireless units in the update process or update your wireless units in batches, please click on to re-scan the connected units. This way you can update additional units without interrupting the update process. 왘 Confirm the following dialog with [Ok].
ADN System Update While updating shows “NOW UPDATING“.
ADN System Update Updating the ADN central units conference manager, the USB drivers and the system release information 왘 Click on [Next >] to update these three components. 왘 When all components are up to date, shows “UPDATE COMPLETE“. 왘 Click on [Exit] to close the ADN System Installer application.
Sennheiser electronic GmbH & Co. KG Am Labor 1, 30900 Wedemark, Germany www.sennheiser.com Publ.
