Instruction manual Set 860
Table Of Contents
- Important safety instructions
- Package contents
- Product overview
- Putting the Set 860 into operation
- Setting up the transmitter
- Connecting the transmitter to an audio source
- Connecting the transmitter to the power supply system
- Charging the stethoset receiver’s rechargeable battery
- Displaying the remaining operating time of the rechargeable battery
- Using the charging reminder function
- Selecting and replacing the ear pads
- Using the Set 860
- Cleaning and maintaining the Set 860
- Using additional functions
- If a problem occurs ...
- Specifications
- Manufacturer Declarations
- Warranty
- In compliance with the following requirements
- Statements regarding FCC and Industry Canada
- RF Radiation Exposure Information
- Information sur l’exposition aux rayonnements radio fréquence (RF)
- Cet émetteur ne doit pas être positionné à proximité d‘une autre antenne ou d‘un autre émetteur, ni utilisé avec une autre antenne ou un autre émetteur.
- Trademarks
Using additional functions
Set 860 | 31
Advanced settings
The advanced settings allow you to adjust the wireless headphone
system to your individual needs and to protect the settings against
accidental changes.
Activating the protected
settings mode
You can change the advanced settings by activating the protected
settings mode:
1 Disconnect the transmitter from the power supply system by
unplugging the connector of the power supply unit.
2 Keep the
Hearing profile
button pressed and connect the
transmitter to the power supply system by connecting the con-
nector of the power supply unit to the yellow socket of the trans-
mitter.
The protected settings mode is activated. The
Transmitter status
LED flashes blue. The LED segments indicate the current settings as
specified in the following chapters:
• battery status display (see page 32)
• charging reminder function (see page 32)
• settings protection function (see page 33)
Deactivating the protected
settings mode and saving the
advanced settings
To save the advanced settings and to deactivate the protected set-
tings mode:
3 Disconnect the transmitter from the power supply system by
unplugging the connector of the power supply unit.
21
1A
1A
3
1A