Instruction manual Set 860
Table Of Contents
- Important safety instructions
- Package contents
- Product overview
- Putting the Set 860 into operation
- Setting up the transmitter
- Connecting the transmitter to an audio source
- Connecting the transmitter to the power supply system
- Charging the stethoset receiver’s rechargeable battery
- Displaying the remaining operating time of the rechargeable battery
- Using the charging reminder function
- Selecting and replacing the ear pads
- Using the Set 860
- Cleaning and maintaining the Set 860
- Using additional functions
- If a problem occurs ...
- Specifications
- Manufacturer Declarations
- Warranty
- In compliance with the following requirements
- Statements regarding FCC and Industry Canada
- RF Radiation Exposure Information
- Information sur l’exposition aux rayonnements radio fréquence (RF)
- Cet émetteur ne doit pas être positionné à proximité d‘une autre antenne ou d‘un autre émetteur, ni utilisé avec une autre antenne ou un autre émetteur.
- Trademarks
Using the Set 860
20 | Set 860
Switching the wireless headphone system off
E Take the stethoset receiver off so that the ear bows fold inwards.
The stethoset receiver automatically switches off after 20 sec-
onds. The transmitter automatically switches off (standby)
when there is no stethoset receiver connected. The
Transmitter
status
LED goes off.
E Always store the stethoset receiver in the transmitter’s charging
compartment to ensure that it is fully charged when needed.
The charging process starts (see page 16).
* LED goes off
To disconnect the transmitter from the power supply system (e.g.
when you are on holiday):
E Unplug the power supply unit from the wall socket.
If the stethoset receiver is outside the transmission range for
more than 5 minutes or if the transmitter receives no audio
signal for more than 30 minutes, the wireless headphone
system switches off automatically (standby).
OFF