Instruction manual Set 860
Table Of Contents
- Important safety instructions
- Package contents
- Product overview
- Putting the Set 860 into operation
- Setting up the transmitter
- Connecting the transmitter to an audio source
- Connecting the transmitter to the power supply system
- Charging the stethoset receiver’s rechargeable battery
- Displaying the remaining operating time of the rechargeable battery
- Using the charging reminder function
- Selecting and replacing the ear pads
- Using the Set 860
- Cleaning and maintaining the Set 860
- Using additional functions
- If a problem occurs ...
- Specifications
- Manufacturer Declarations
- Warranty
- In compliance with the following requirements
- Statements regarding FCC and Industry Canada
- RF Radiation Exposure Information
- Information sur l’exposition aux rayonnements radio fréquence (RF)
- Cet émetteur ne doit pas être positionné à proximité d‘une autre antenne ou d‘un autre émetteur, ni utilisé avec une autre antenne ou un autre émetteur.
- Trademarks
Putting the Set 860 into operation
Set 860 | 15
Connecting the transmitter to the power supply
system
1 Connect the connector of the power supply unit to the yellow
socket of the transmitter.
2 Select a suitable country adapter and slide it onto the power
supply unit until it clicks audibly into place.
3 Plug the power supply unit into the wall socket.
All LEDs on the transmitter light up for 5 seconds. The transmit-
ter is in standby mode.
US
EU
UK
AU
2
1
3
Power
1A
1A