User Guide
39
Using the components
Muting the devices
Muting the bodypack transmitter
Slide the MUTE switch to the left, to “MUTE“.
The red LED LOW BATT/MUTE lights up perma-
nently. The MIC level display no longer shows
any deflection. The bodypack transmitter’s micro-
phone input is muted.
Note:
The muting function (MUTE) mutes the microphone
input but not the line input . This function
enables a pre-recorded track to be played through
the line input without being disturbed by the tour
guide’s microphone. When the track has finished,
the guide can un-mute the microphone and con-
tinue talking.
To deactivate the muting function:
Slide the MUTE switch back to the right.
The red LED LOW BATT/MUTE goes off. The MIC
level display and the LINE level display indi-
cate the current levels.
Muting the radio microphone
Turn the protective cap so that the MUTE
switch becomes accessible.
Slide the MUTE switch in the direction of the
arrow.
“MUTE” appears on the display of the radio micro-
phone. After 5 minutes, “CH OFF” appears on the
display (see “Display of the energy saving mode”
on page 16).
To deactivate the muting function:
Slide the MUTE switch back in order to transmit
the audio signal again.
LINE
CH 03
MIC