User's Manual

70
Using the components
Switching the components on/off
The ew 100 G2 transmitters and receivers can only be switched off when the
standard display is shown on the display panel. Within the operating menu,
the
ON/OFF button or the POWER button (EM 100 G2 only) serves as the ESC
(cancel) key, i.e you cancel your entry and return to the standard display.
Note:
Remove the batteries or the accupack when the units will not be used for
extended periods of time.
Switching the rack-mount receiver on/off
왘 Press the POWER button  to switch the receiver on.
왘 To switch the receiver off, press the POWER button until “OFF” appears on
the display.
Switching the bodypack receiver/transmitter on/off
왘 Press the two unlocking buttons  and open the battery compartment
cover
.
왘 Press the ON/OFF button  to switch the bodypack receiver/transmitter
on. The red LED
 lights up.
왘 To switch the bodypack receiver/transmitter off, press the ON/OFF button
 until “OFF” appears on the display. The red LED  goes off.
왘 Close the battery compartment. The battery compartment cover  locks
into place with an audible click.
Switching the plug-on transmitter on/off
왘 Press the ON/OFF button  to switch the plug-on transmitter on. The red
LED
) lights up.
왘 To switch the plug-on transmitter off, press the ON/OFF button  until
“OFF” appears on the display. The red LED
) goes off.







ew100.book Seite 70 Mittwoch, 8. Oktober 2003 12:52 12