User's Manual

66
Mounting the bodypack receiver to a camera
Use the supplied camera kit to mount the receiver to the camera’s flash
mount.
The camera kit consits of:
y1 perforated plate

y1 flash mount adapter 
y2 square nuts 
왘 Determine where on the perforated plate the flash mount adapter  will
need to be fastened so that the receiver can best be attached to the
camera.
왘 At this position, place a square nut  under the perforated plate .
왘 Fasten the flash mount adapter to the perforated plate using the square
nut.
왘 Remove the belt clip.
왘 Place the perforated plate  onto the rear of the receiver.
왘 Reinsert the belt clip.
SK 100 G2 bodypack transmitter
Inserting and replacing the batteries
For powering the SK 100 G2 bodypack transmitter, you can either use two
1.5 V AA size batteries or the rechargeable Sennheiser BA 2015 accupack.
왘 Press the two unlocking buttons  and open the battery compartment
cover
.
왘 Insert the two batteries or the BA 2015 accupack as shown in the diagram
on the left. Please observe correct polarity when inserting the batteries/
accupack.
왘 Close the battery compartment. The battery compartment cover  locks
into place with an audible click.
Note:
For important informations on charging the accupack see: „Inserting and
replacing the batteries“ on page 65.
Connecting the microphone/line cable
The microphone/line input is designed for the connection of both condenser
microphones and instruments (e.g. guitars). DC powering of the condenser
microphones is via the microphone/line input.
왘 Connect the 3.5 mm jack plug  from the microphone/line cable to the
3.5 mm jack socket (MIC/LINE)
&.
왘 Lock the 3.5 mm jack plug by screwing down the coupling ring .
왘 Via the operating menu, adjust the sensitivity of the microphone/line
input (MIC/LINE) (see: „Adjusting the sensitivity (transmitters only)“ on
page 80).








ew100.book Seite 66 Mittwoch, 8. Oktober 2003 12:52 12